Machining and Reconditioning of Connecting Rods

TRAC's Con Rod Department is responsible for the machining and reconditioning of connecting rods of all sizes from diesel and natural gas engines.

The rods go through a rigorous examination process to determine the rod’s re-usability. The rods that pass this scrutiny receive new bushings that are then cut to size providing a smooth surface that is ready to return to its application.


Don’t risk further damage. Contact the team at TRAC with any engine-related questions you may have.

Services Offered

  • Check for straightness
  • Check center to center dimension
  • Check side thrusts
  • Conduct wet Magnaflux test
  • Resize journal end
  • Re-bush wrist pin end and finish to size
  • Heat bushing end if required for installation
  • Broach bushing when required
  • Bushing retention check if needed

Rocker Arm Service

Many customers also require the reconditioning of rocker arm assemblies. As these are part of the moving valve train, a certain amount of wear is expected.

  • Measure and check for re-usability
  • Regrind valve end to original contour
  • Polish shaft bore
  • Polish rocker shafts
  • Magnaflux if requested
  • Update oil passages

TRAC Engine Services Ltd

11235 - 154th Street

Edmonton, AB T5M 1X8

Service Area

Edmonton

Phone

780-452-2035

Toll Free

1-866-322-2357

Fax

780-452-5642

Monday: 8:00 AM - 5:00 PM
Tuesday: 8:00 AM - 5:00 PM
Wednesday: 8:00 AM - 5:00 PM
Thrusday: 8:00 AM - 5:00 PM
Friday: 8:00 AM - 5:00 PM
Saturday: Closed Sunday: Closed

Send to a friend

Send the url of this page to a friend of yours

Copyright TRAC Engine Services Ltd 2017 - Legal
Created by

Legal notice